LED display using the process

To ensure that our products can be used under the condition of reasonable normal, get your recognition of products, we will review process as well as the matters needing attention on the use of the products, please read carefully, then LED display installation and commissioning work.

1 use hardware equipment list:

LED display signal cable power cable system control card (load) in a computer system to accept charge CARDS (load) within the LED display desktop computers (including the DVI video output and serial port) screens and related ancillary fittings.

2 use process

Hardware installation steps are as follows:

1, the DVI display card inserted in the motherboard of AGP slot, the card is installed driver;

2, put in an empty PCI data acquisition card slot (if any);

3, the data acquisition card and display card with DVI cable connected together;

4, the control line connected to a serial port (Rs232) (optional, ling star rain system needs).

5, with cables are connected to the receiving card; (specific article number according to the engineering drawings)

6, check the connection and correct Settings can be made or on electrical debugging.

Software installation steps are as follows:

1, the graphics driver installation

Insert the video card driver CD drive, can be automatically entered into state of the installation, please follow the instructions. First installation DirectX8.1; Then install driver; The final installation control panel.

2, play the software

Shown special installation screen with LED studio set up software, control software or other insert with the screen attached to the application software CD drive, copying or installing all programs on the computer.

3 electronic screen operation steps (important)

1, the tail: please open the computer, then open the electronic screen. For each equipment to the power () to ensure that the input voltage conform to product requirements to open the LED screen, the screen body electric moment there will be a regional flicker, show the screen body electricity), open the computer, make sure the graphics Settings right (incorrect will not show the picture, the black screen), open the control software, basic pixel size and display area set (this setting does not affect the display of the LED display screen)

2, GuanBing: first, turn off the LED screen power supply, turn off the control software, and then shut down the computer properly.

4, found the problem

1 check all wiring way is correct, including, in high voltage connection part (elv part has been completed in production testing), signal connection is correct, the main direction for the system to receive card input and output is correct, has direction signal receiving card. System connection is correct (please read instructions) system of computer software part whether to complete the installation, including graphics Settings (please read graphics Settings) and control software installation.

5, matters needing attention

1, abide by the "user manual" of the operating steps;

2, moisture, humidity requirement is: the highest working temperature, the LED display should be less than 92% relative humidity

: 3, appropriate temperature, temperature requirements for the working environment temperature - 20 ° C t 80 ° C or less or less, storage environment temperature to 40 ° C or less t 60 ° C or less

4, conform to the requirements for power supply: LED display of the power supply voltage: 220 v + 10% : frequency 50 hz plus or minus 5% safe earth contact reliable, reliable ground wire from the zero line, plugged into a power supply from high power electric device.

In the other problems in the operation process, please read our related instructions, if you have questions, please contact us.